Turtle Sliding Gate Opener 24V for DIY Installation/ SGO-BB-24

Turtle Sliding Gate Opener / SGO-BB-24DIY
Extras & Accessories
Remote control
Wireless keypad for Gate opener
Push Button for Gate Opener
Nylon gear rack
Power supply
IR Safety beam
RFID Keypad wired
GSM Switch
Remote Gate Opening
Backup battery
Add Backup batteries to power your gate during power cuts. 2x 12V 9A batteries wired in series for
$449.00
SGO-BB-24STD
+ −
Add to My Favorites
Shipping estimate:
Your city

TURTLE DIRECT© 

Turtle Sliding Gate Opener SGO-BB-24STD

Not quite sure what kind of gate opener you need or how to power it?  How to find the right Gate Opener?

IMPORTANT: This system is only suitable for gates installed on level ground. The maximum gate length should not exceed 6m.

If you have 230VAC power available at your gate, the standard model will serve your needs. Simply connect this available power to the transformer coil within the motor housing and your motor is operational.

Find the ideal, uncomplicated solution for residential settings where mains power is accessible at the gate.

If you lack 230VAC power at the gate, consider upgrading to the DIY set. This allows you to use a nearby power point to connect the transformer coil, and then run a low voltage cable to the gate independently. There's no need for digging trenches or hiring an electrician.

We provide detailed installation instructions. Gate hardware installation kits and additional accessories can be found in our web shop.

This system caters to gates up to 800kg.


Backup batteries (2x 12V9A) can optionally be stationed within the motor housing for backup during a power cut.

Technical Data:
Power supply: 230VAC to Stepdown transformer = 24V
Gates up to 600kg and 6m length on level ground.
Motor output: ca. 300W
Gate speed ca.: 14m p. minute
Auxiliary power output: 24VDC 3W max.
Weight (no battery): ca. 9.0kg
Dimensions: H: 288, L:300, W:202mm
Working temperature: -10 - +55°C
Remote controls: 433.92 MHz
Max remote controls: 25+
Flashing beacon output

Operate the gate opener:
Remote control (2 included)
Push button (optional)
Keypad (wireless or wired) (optional)
IR safety sensors (optional)

Included:

  • 1x Gate opener SGO-BB-24
  • 4x 1m Nylon rack  / steel rack is optional  (same price)
  • 2x Remote control
  • 1x Weather-proof Enclosure with step down transformer to plug in at garage (only included if upgraded to DIY system!)
  • Manual

Warranty: 12 months RTB
Consumer Guarantees Act applies

Photos are general examples and indicative only / NO battery necessary, but can be used for backup and are optional.

TURTLE DIRECT© TURTLE Gate Automation©